head touque

[jody]

i am installing a 70cc kit and it says nothing about cyl. head torque can anyone tell me the torque spec.

[Elliott]

Don't Know Much but From what i here you have to have As Well Most Cylinders are 11 to 12

[jody]

thanks for your reply

But if any one can confirm that answer i would be grateful. :D

On the directions it says you grease the head gasket. Is this true :eek:


please help me i need to get this finished :)

[Elliott]

Contact Jered! he has a 70CC he might have your answer!!

but dude to me it really don't Matter!! just as long as there Tight

the best thing you can do is Turn each Bolt 4 Strokes

write it down on paper

Run the bike for a Bit to check for leaks ...

now on my bike i turn it 4 strokes on each Bolt!!

but this is a 70cc not a 49cc like mines So you might have to use more Bolt strokes ,Do to the Pressure!!! which is more then a 49cc

i checked the search engine Google for you on cyl. head torque

Did not find Anything on it!!!

Hope This Helps Goodluck :cool:

[jody]

ok sounds good

i just like every bolt to be even

I am going to torque to 12 foot pounds and post the results :D

and about the grease :confused:

[Elliott]

Make Shure you dont Turn them To Much or You Will STRIP THE TREADS in back of the Cylinder Chamber :eek:

And the ROD won't Tighten and you will Leak Pressure!!! :mad:

[XPS1210]

Like I said... I have never torqued them down...

Bottom line is don't tighten them so they snap... you can feel how tight, tight enough is...

Don't over tighten, but don't finger tighten...