clockworx
09-01-2004, 01:17 PM
Putting my stock carb back on, I have 2 screw sleeves that I don't
remember how they were originally on. (This is on the side attached the the rubber hose OPPOSITE the air intake) I took a guess and put them on as:
screw top
large sleeve
clasp top
small sleeve
clasp bottom
end of screw (I assume no sleeve can go on the end of the screw?)
So the large sleeve asks as a spacer between the screw head and the
top of the clasp, and the small sleeve is a spacer between the two
screw holes in the clasp. Anyone recollect what the right order is,
or have a close-up shot of a stock carb?
I know this is a simple/silly question, i just want to make sure I re-assemble it right, as it is still under warranty and I don't want it to appear altered (I just wanted to clean the jets with compressed air).
Thanks
remember how they were originally on. (This is on the side attached the the rubber hose OPPOSITE the air intake) I took a guess and put them on as:
screw top
large sleeve
clasp top
small sleeve
clasp bottom
end of screw (I assume no sleeve can go on the end of the screw?)
So the large sleeve asks as a spacer between the screw head and the
top of the clasp, and the small sleeve is a spacer between the two
screw holes in the clasp. Anyone recollect what the right order is,
or have a close-up shot of a stock carb?
I know this is a simple/silly question, i just want to make sure I re-assemble it right, as it is still under warranty and I don't want it to appear altered (I just wanted to clean the jets with compressed air).
Thanks