Stage 2+ Installed...HELP!

[pantaloneus]

I know questions like this come all the time. I need help. I just installed the Airsal T-6, Arreche 19mm carb, Unifilter Airbox, Malossi Over Range, Malossi Winged Clutch Bell, RS Pipe, CF Reeds valves, Malossi Upgear. Red TQ Spring, 3.2?g rollers.

Anyway I just put it all together and went to kickstart it but nothing happened. I went to the store bought siphon pump and gas can so I will be able to put new pre-mixed gas to it. So any ideas of why it didn't start?? I am still new and trying to learn about it all myself but if could get help I'd love to get it running. Mabye starter fluid?

[TheMontrealGuy]

Some might not agree with me but try and install the least amount of aftermarket parts at a time. Ex: start by putting the carb and reeds. Start the scoot. If it orks then put the new engine. Start it if it put the upgears. If it starts put the overrange kit.

If you just shove everything in and it doesn't work, there are 100's of things that can be the problem.

I would recoment checking your spark. If there is one, check if there is fuel in your carb.

[pantaloneus]

Yes I know that I should have done it one at a time but I was impatient and did it all at once. Any Ideas as to why it wouldn't start or even sputter? Is there something else I need to do to get the new carb or cyl. ready since they have never been ran before?

[StepVino]

Mine has always had trouble starting after the cylinder has been
off. Make sure your plug is not wet, then use some starter fluid
and crank it with throttle wide open. If it starts, don't let it rev too
high, close the throttle and let it die the first time. Try again.

[pantaloneus]

BAM! You're the man. I took out the mallosi tranny and put the stock back on (less to troubleshoot and less effort to start with?) It started right up. Rode it down the street and on a flat plane. From 0 - 10 normal, 10 - 15 fast, 15 - 20 normal, 20 - 25 'lil slower, 25 - 30 sloww, 30 - 35 normal, 35 + good strong climb till off gauge. I'm going to tune carb and tran tomorrow any suggestions? I know it may sound weird I have uncomplete setup I.e. malossi upgear, stock tran, 70cc + 19mm carb, cf reeds. I also forgot to check the stock settings on carb. But just happy its alive