Razz cylinder torque

[binzing]

Hey, not that I need to right now but I may later need to remove the head. Whats the torque for the head bolts? Thanks

[binzing]

Is there even a torque requirement, or do you just make them wrench tight? I assume there is, but correct me if I'm wrong.

[Lennox]

check the manual for the Zuma on the sales page. The specs should be the same.... or at least better than "hand tight"

[dwsracing]

I just do a ,it's tight. You don't want to over smush the brass, but evenly tighten. It's a feel thing for me.
If I find my spec. sheet I will let you know.