zuma rev limiter

[hybridrazz]

i think i can feel my rev limiter holding me back feels like the scooter slows down a little, then speeds back up just wondering if anybody else had this problem with there factory limiter still on with the 70cckit,exhaust,and carb?

[Lennox]

new or old Zuma? For the old Zuma, you can cut the red wire (i think its red) to dissable the limiter.

Do you have a tach? I do not think that the setup you have will reach the limiter? :confused:

[marylandmark]

Try this link. (http://www.provoscooter.com/vbull/showthread.php?t=915) - Not sure if this will help but worth reading and I am sure someone else can pipe in on this thread to shed more light on the subject..

[marylandmark]

Sorry-

I went to "New Post" and didn't see what forum (Old Zuma) you were in..(I am guessing Lennox did the same thing..)

Anyway-

Lennox was corrct-

On early BWS motors the rev limiter can be removed by disconnecting the red wire from the CDI (Capacitor Discharge Ignition) unit to the wiring harness.

[hybridrazz]

well i guess im just going to try the cdi unit its the only basic mod i havent did yet, gives me a good excuse to move on to the evo or jollymoto exhaust and the evo cylinder,and the intake manifold with the 4petal reed block.